Konsberg AIS 200, Installation Manual

Page: 42 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Connecting & configuring external equipment
4.3.3 Input sentences
Sentence Content
LRI Long-range interrogation
LRF Long-range function identification
4.3.4 Output sentences
Sentence Content Transmission interval
LRF
Long-range function
identification
When LR response sent
LR1 Long-range response
When LR response sent
LR2 Long-range response When LR response sent
LR3 Long-range response When LR response sent
4.4 Sensor input
4.4.1 Physical location
Sensor1 is installed on P1, pins 16 - 20, Sensor2 is installed on P1, pins 6 - 10 and Sensor3 is
installed on P1, pins 1 - 15, see figure on page 25.
These ports are mainly intended to serve as inputs from ships' primary navigation systems
such as position sensor data and heading sensor data (the ports are configurable and
transmission of two-way data is possible).
4.4.2 Port configuration
The sensor inputs Sensor1, Sensor2 and Sensor3 are equivalent and the default settings are as
follows:
Baud Rate Parity Bits Stop Bit
4800 N 8 1
The baud rate is configurable from 1200 to 57600. Refer to
Configuring external serial
ports , pages 37 and 95.
32