FUEL FILTER
15
1. Remove the fuel tank cap and fuel filter.
2. Clean the filter with gasoline.
3. Wipe the filter and replace it.
4. Replace the fuel tank cap.
Make sure that the fuel tank cap is tight.
Never use gasoline while smoking or in the immediate
vicinity of an open flame.
IMPORTANT!
To drain gasoline from the carburetor, turn off the fuel
valve and wait until the generator has cooled down
sufficiently. Place a drip pan under the carburetor
and loosen the drain screw on the carburetor (see
fig.). Make sure that no fuel leaks onto the generator.
Tighten up the screw again.
STORAGE
16
Storage room has to be dry and free from dust deposits. Storage room also has to be locked away from
children and animals. It is recommended to store and use the generator at temperature of -20°С to +40°С.
Avoid direct sunlight, rain on the generator. Information on long-term storage and transportation can be
found in the full version of the manual.
GENERATOR DISPOSAL
17
To prevent environment damage generator should be separated from ordinary waste. Please
recycle them in the safest way, passing it to special place for disposal.
Potential faults and troubleshooting methods, as well as average device capacities can be found in the
Potential faults and troubleshooting methods, as well as average device capacities can be found in the
full version of the manual.
full version of the manual.
Match the protrusion of the flame arrester to the hole
in the pipe damper.
IMPORTANT!
DAMPER AND FLAME ARRESTER
MAINTENANCE
14
The engine and damper will get very hot after the generator has been started. Do not touch the engine or
damper with any part of your body or clothing during inspection or repair until they have cooled down.
Remove the screws and then pull the protective cover towards you. Loosen the bolts and remove the cover,
screen and flame arrester of the damper. Descale the screen and flame arrester of the damper with a wire
brush.Inspect the screen and flame arrester of the damper. Replace them if they are damaged. Replace
the flame arrester. Replace the screen and cover of the damper. Replace the cover and tighten the screws.
SPARK PLUG VERIFICATION:
SPARK PLUG VERIFICATION:
1. Remove the cap from the spark plug.
2. Remove the spark plug by means of a corresponding spanner.
3. Examine the spark plug. If is is shattered – it is necessary to replace it.
Recommended replacement spark plugs – F7TC.
4. Measure the gap. It has to be within range 0.7-0.8 mm.
5. In case of repeated use, the spark plug has to be cleaned by means of a metal brush.
After that – set the correct gap.
konner-sohnen.com
|
8
Summary of Contents for KS 48V-DC
Page 11: ......
