Könner & Söhnen KS 15TKG 52/35, Owner'S Manual

Page: 14 / 17

REPLACING HYDRAULIC OIL FOR MODEL KS 27THG 65/55 REPLACING HYDRAULIC OIL FOR MODEL KS 27THG 65/55
Replace the hydraulic oil in the log splitter after every 150 hours of use. Take the following steps to replace
the oil:
1. Make sure all moving parts are stopped and the log splitter is unplugged.
2. Unscrew the oil drain bolt.
3. Place a drip tray under it to drain spent oil.
4. Fill with fresh hydraulic oil. As stated in the Specifications Table on page 2 the correct oil capacity is 20 L.
5. Clean the surface of the dipstick, which is attached to the oil drain bolt, with a clean lint free cloth and
put back into the tank to check the new level. Make sure the level of the refilled oil is just between the two
grooves around the dipstick.
6. Clean the oil drain bolt before screwing it back. Make sure it is tightened to avoid leakage before placing
the log splitter horizontally.
What When How
Hoses Every use
Inspect for exposed wire mesh and leaks. Replace all
worn or damaged hoses before starting the engine.
Hydraulic fittings Every use
Inspect for cracks and leaks. Replace all damaged
fittings before starting the engine.
Nuts and bolts
Every use
Check for loose bolts.
Beam Every use Apply grease to beam surface.
Moving parts Every use Clear debris.
Periodically check the oil level to ensure it is between the
two grooves on the dipstick. Refill when the oil reaches
the lower level.
NOTICE
Use hydraulic oilI SO VG 22.
The following hydraulic oils or equivalent are recommended for the log splitter’s hydraulic transmission
system:
- SHELL Tellus 22
- MOBIL DTE 11
- ARAL Vitam GF22
- BP Energol HLP-HM22
TROUBLESHOOTING
TROUBLESHOOTING
Malfiunktion Possible trouble Troubleshooting
The engine
does not start
Insufficient oil in pump Check oil level in reservoir
Air in oil Check oil level in reservoir
Engine circuit breakeris in the OFF
position
Bring the engine circuit breaker to ON position
www.ks-power.de/en
|
13