3
Time Setting
Time display: 12 Hours system and 24 Hours system.
12 Hours system
24 Hours system
Once batteries are putted into the device, 24 Hours system is used.
long press [MODE] button, enter the time setting mode. “Hour” digit
is blinking and ready for setting, Press [ADJUST] button to change
“Hour” digit.
Press [MODE] button, “Minute” digit is blinking; press [ADJUST]
button to change “Minute” digit.
Press [MODE] button, then press [ADJUST] button, 12 hours system
and 24 hours system are inter-changeable.
Press [MODE] button, “month” digit is blinking; Press [ADJUST]
button to change “month” digit .
Press [MODE] button, “date” digit is blinking; Press [ADJUST] button
to change “date” digit .
Press [MODE] button, “week” digit is blinking; Press [ADJUST] button
to change “week” digit .
Long press [MODE] button for confirming the setting.
Compass Mode
The device will only stay in compass mode for 4 minutes for saving
power consumption, press [Compass] button to enter compass mode
again.
Press [Compass]
During you use, if the digital compass mode is destroyed, the data is
inaccuracy, it means that you must run the calibration process, at this
time, long press [Compass] button (hold the button about 4 seconds),
enter the calibration mode, then you can calibrate the device over
again as the above-mentioned calibration step.
Back Light
Press [Light] button, turn on the backlight for 4 seconds.
Precautions
1. The device is not designed as a commercial navigation device.
2. Never place the device near magnetic field equipment.
3. Batteries should be removed when the device is not in use for a
long period of time.
4. Avoid short-circuit of the battery terminals by following the polarity
indicated inside the battery compartment.
5. Do not mix old and new batteries. Also do not mix alkaline,
carbon-zinc or rechargeable (Ni-Cd/Ni-H) batteries.
6. Do not dispose batteries into fire.
7. Avoid extreme temperature, strong shake, drop into water.
