![KONIG ONSTAGE OSP-SX110ta User Manual Download Page 4](http://html1.mh-extra.com/html/konig-onstage/osp-sx110ta/osp-sx110ta_user-manual_1995821004.webp)
4
CONNECTIONS
The system has a female XLR input that accepts a balanced line-level signal.
When connecting a balanced signal, be sure it is wired to AES (Audio Engineering Society) standards:
If connecting an unbalanced signal to the system balanced input, be sure that the signal high (hot) connection
is wired to pin 2 and the unbalanced ground connection is wired to the low and the ground connections of the
balanced input. If there is a ground-loop problem, try connecting the unbalanced ground connection only to
the input low connection (pin 3), and leaving the input ground connection disconnected.
The through output connectors allow you to connect more than one bass or other active speaker to your
system.
Simply plug the full range input jacks into the first speaker, and patch that speaker through jacks to the next
speaker as input jacks, and so on, daisy-chaining multiple speakers. The through jack is wired straight from
the full range input connector (there is no electronic circuitry between), so the signal coming out of the through
jack is exactly the same as the signal going in.
PLACEMENT
The bass system is designed to sit on the floor.
Never attempt to suspend the system by its handles. As with all electrical components, protect the system
from exposure to moisture.
If you are setting the system up outdoors, make sure they are covered if you expect rain.
AC POWER
Be sure the system is plugged into an outlet that is able to supply the correct voltage specifically for your
model. Also be sure that the electrical service can supply enough amperage for all the components connected
to it. We recommend that a strong supply of AC power is used because the amplifiers place high current
demands on the AC line.
Poor bass performance is often caused by a week AC supply to the amplifiers. Never remove the ground pin
on the power cord of the bass or any other component.
SPECIFICATION
OSP-SX110ta OSP-SX112ta
TOP / 10” FULL RANGE
TOP / 12” FULL RANGE
Cabinet
Mid / High
Mid / High
Full range
Full range
Configuration
Compact 2-way
Compact 2-way
Nom. Impedance
4 Ohm
4 Ohm
Rated Power RMS
200 Watt
300 Watt
SPL 1 w/1 m
100 dB
101 dB
Frequency Response
(-10 dB) 55-20 KHz
45-20 KHz
Coverage Angle
90° × 40°
90° × 40°
Crossover Frequency
3000 Hz
2000 Hz
Voice Coil Protection
PTC
PTC
Components High
1” Driver
1” Driver
Components Mid (Low)
1x10/200
1x12/300
10”
12”
Material
Plywood 18mm
Plywood 18mm
Finish
Black lacquer
Black lacquer
Dimensions (w x h x d cm)
36x56x38
42x62x43
Net Weight (kg)
19
25