14
4. Motor Setting: Press
OK
to show the Motor
Setting window. Satellite: Press
to select the
satellite in circle. Or press
OK
to pop up the drop-
down list, then select the desired satellite in the list
and press
OK
to confirm.
Transponder: Same operation as above.
Position No., & Save: The range is from 0 to 63. “0” delegates the original position. Select the
proper value when you have rotated the antenna.
Go to X: Press
OK
to pop up the drop-down list, select the proper position (reference or from 1 to
63) to realize the selected position.
West <Save> East: Press ^ key to turn west, while pressing it to turn east.
Press
OK
to pop up the dialog “Are you sure to change this satellite’s position?” Press
OK
at the
Yes button to save the current position, or press
OK
at the No button to cancel the operation.
Recalculation: Press
OK
to pop up the dialog “Are you sure to change this satellite’s position?”
Press
OK
at the Yes button to recalculate.
5. Limit Setup: Press
OK
to pop up the Limit Setup
window.
Limit Setup: Press
to toggle among
Disable Limit, East Limit and West Limit. Limit
Setup: Move cursor to the Limit Setup button.
Press
to turn west, or press
to turn east.
Go to Reference: Press
OK
to go to reference. If
you select Disable Limit in the above Limit Setup,
this button will turn grey.
6. If select USALS, Delete All item will turn grey.
Local Longitude, Local Latitude: Press
to switch between West and East, or press
to switch between North and South.
Press
OK
to enter the editing mode. Use the
numeric keys (0-9) to input the longitude or
latitude, press
MENU
or
EXIT
to exit. The range
of the longitude is from 0 to 180°, while the range
of the latitude is from 0 to 90°. If the entered
value is not within this range the system will pop
up a dialog “Out of Range” when you exit from
this window. Press
OK
to close this dialog.
7. Motor Setting: Press
OK
to enter into the Motor
setting window. Satellite, Transponder: Press
keys to select satellite or transponder,
or press
OK
to pop up the drop-down list and
select in the list.