USAGE NOTES / FUNCTION
SAFETY NOTES
- Maximum Load 50 kg.
- Be sure that the surface will bear the load and is suitable and level.
- The fact that the product is collapsible and adjustable, can result in the risk of pinching/wedging.
-
Careful and attentive handling during setup, operation, and disassembly is indispensable.
- Prior to placing the instrument on the stand ensure that the mesh teeth of the adjustable locking clamp
-
are properly meshed and the excenter clamp lever is in a locked position (parallel to the tube).
- Ensure that the weight on the stand is centered and select the proper setting width (refer to Section TIPS)
- The end caps are made of high quality material and to the extent possible free of softening agents.
-
To protect particularly delicate floors (e.g. certain wood floor types) a slip resistant pad should be used, if needed.
1
Setup the stand such that the support arms (250 mm) are on the top and the base tubes (500 mm) are on the bottom.
2
Open the excenter clamp lever so that the teeth are in an un-locked position.
3. Position the top tubes such that the desired height/width is attained.
4
Close the excenter clamp lever so that the teeth are in a locked position.
4
NOTE:
4a
The teeth points should not be pressing against each other. If this is the case adjust
4a
so that the teeth line up properly.
4b
The lever must go past the excenter point as far as it will go and be parallel to the stand tube.
4b
This position is mandatory, in particular when it is being used with a load, but also when it is being
4b
transported or stored. The lever may only be in an open position when the stand is being setup or taken
4b
down. Otherwise, it is in an improper position.
5
In the case of an uneven surface adjust the balance end caps accordingly (+/-).
ADJUSTMENTS
The discs are
intermeshed in
5° intervals.
The provides the options
to position both
bases in 30 different
positions.
SETUP INSTRUCTIONS
SCALE
Based on a scale and
a marking (X)
on the disk that is located on
the other
side, the stand can
be adjusted to exact
specifications.
As such the preferred
specifications
can be easily found each time
the stand is setup.
18990 Keyboard stand »Rick 20«
- Premium X stand - comfortable and extremely sturdy
- Thanks to the new assignment of the double brace stand tubes, which provide for robust stability and safety
- The depth of 250 mm of this keyboard stand is perfect for all common stage pianos
- The ergonomic clamp lever makes it easy to setup the keyboard stand and
-
collapse it in a flash
- The robust metal joint is intermeshed in 5° steps and provides a multitude of
-
different positions
- The scale provides the user with the option to always select their preferred setting
- With typical K&M quality features such as:
-
solid workmanship, high quality surface coating, anti-slip rubber rests
-
and practical balancing end caps for uneven surfaces
- Height/width are universally adjustable, base tube: ø 30 x 500 mm, top tubes ø 30 x 250 mm
- Weight: 5.6 kg
Thank you for choosing this product. The instructions provide directions to all of the important set up and
handling steps. We recommend you keep these instructions for future reference.
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
18993-015-55 Rev.07 / 18993-015-76 Rev.06 03-80-688-00 2/17
