TEMPLATE
Screen
VESA-
Standard
OPTIONS
Mounting
SIZE
Screen
SET OF SCREWS (please refer to section 1 partial overview)
(Deviations from the VESA standard are possible)
Width: 300 - 800 mm
Height: 200 - 500 mm
MIS-F
Vertical tube with
mounting strips
42" to 65"
M6x16 - Pos.-No.: 20 21 22 - Bag 3
M8x20 - Pos.-No.: 23 24 25 - Bag 4
Cylinder screw Washer Plastic connectors
5. PREPARE THE SCREEN/MONITOR STAND
6. SCREEN/MONITOR
6.
MOUNTING
3. DIMENSIONS
NOTE:
You may see the term VESA in the screen/monitor description.
NOTE:
This is the technical guideline used to affix the screen/monitor. In many cases, the screens/monitors correspond to these
NOTE:
instructions - if the screens/monitors deviate from these instructions please refer to the screen/monitor manufacturer.
THREE THINGS
are to be checked prior to mounting the screen/monitor:
1. TEMPLATE
(= Distance of the threaded holes on the back of the screen/monitor (in mm))
2. SIZE OF THE SCREW THREAD
customary: M6 or M8 - a suitable set of screws is, however, provided (see TABLE as well as
Section 1 Packaging and Parts Overview))
3. MAXIMUM SCREW DEPTH
(according to VESA - M8: max.15 mm, M6: max.10 mm)
a. in the case of flat threaded holes: the provided screw sets are adjusted to the maximum screw depth
b. in the case of inset threaded holes: purchase longer screws which correspond to and do not exceed the maximum screw depth
(For example: depth 5 mm, new: M6 x 15 mm)
c. in the case of super flat screens: in some cases shorter screws are needed - please refer to the information provided by the manufacturer.
TABLE
: The SCREW PLACEMENT TEMPLATE of the Screen/Monitor determines how the Screen/Monitor is affixed to the stand.
ASSEMBLY SET
3
Mounting strips 2x
5
Vertical tubes 2x
5a
Cylinder screws 4x
11-14
Set of screws 4x
15
Washers 4x
17
Key SW5
18
Key SW3
19
Key SW10/13
ENSURE:
Each slot contains
a movable nut slot
Cylinder Screw M6 x16 mm
5a
secures the position during transport.
4. HEIGHT ADJUSTBALE using the spring-loaded clamping knob
Weight:
15.5 kg
space for
cables
ATTENTION!
Turn the clamp
screw approx.
1/2 turn to
loosen.
NEVER
fully remove
the clamp screw.
First person:
- holds the extension
-
arm
Second person:
- pulls the handle
-
until the security
-
bolt is no longer in
-
place
First person:
- extends or retracts
-
the extension arm
Second person:
- at the same time
-
pulls the spring-
-
loaded clamping
-
knob to an open
-
position
First person :
- holds the tube, so that the bolt/pin can catch
- TIP: the next higher hole is located just above
-
the tube collar
Second person :
- places the security bolt/pin of the clamp handle
-
in the desired hole and tightens the clamp
-
handle.
ATTENTION!
When adjusting the height ensure that the
extension arm is being held by person A, while
person B is adjusting the spring-loaded clamping
knob.
NOTE: please refer to the separate instructions for
the SECURITY PIN/BOLT alternative.
ATTENTION!
To ensure that the
locking bolt
clicks into place,
do not turn the tube.
