USAGE NOTES / FUNCTIONS
SAFETY NOTES
1
Setup the stand, such that the top tubes (250 mm) are on top
1
and the feet tubes (500 mm) are on the bottom.
2
Open the excenter clamp lever so that the teeth are not in a locked position.
3
Position the top tubes such that the desired height/width is attained.
4
Close the excenter clamp lever so that the teeth are in a locked position.
4
ENSURE: The teeth points must not be pressing against each other.
4
ENSURE:
If this is the case adjust so that the teeth line up properly.
5
In the case of uneven surface adjust the balance end caps accordingly (+/-).
SETUP INSTRUCTIONS
SCALE
Based on a scale and a
X
marking on the disk on the
other side, the stand can be
adjusted to exact
specifications.
As such, the exact
specifications
can be easily set each time
the stand is setup.
18933 Keyboard Stand
- uncomplicated easy to use scissor stand with variable
-
adjustments - both in height and width
- now with a new centrally placed ergonomic excenter clamp lever
- mesh teeth joint with small 5° increments and scale (see USAGE NOTES below)
- boasts the typical K&M quality characteristics:
-
solid workmanship, smooth handling, easy to transport, high quality surface
-
protection, anti-slip adjustable rubber top for keyboards variable depth,
-
balance end caps for uneven surfaces
- height/width adjustable; Base Tube: ø 30 x 500 mm, Top Tubes ø 30 x 250 mm,
-
weight: 3.8 kg
Thank you for choosing this product. This instruction manual informs you about the important
steps to set up and handle the product. We recommend to keep the manual in a separate place
for a possible later use.
- maximum load 50 kg.
- be sure that the surface will bear the load and is suitable and level.
- the fact that the product is collapsible and adjustable can result in the risk of pinching/wedging.
- careful and attentive handling during setup, operation, and disassembly is indispensable.
- prior to placing the instrument on the stand ensure the mesh teeth of the adjustable locking
-
clamp are properly meshed and that the excenter clamp lever is in a locked position (parallel to the tube).
- the end caps are made of high quality material and to the extent possible free of softening agents.
-
To protect particularly delicate floors (for example: certain wood floor types) a slip resistant pad should be used.
ADJUSTMENTS
The discs are
intermeshed in
5° intervals.
This provides the options
to position both
bases in 30 different
positions.
