12331 Orchestra conductor
stand base
- High quality base to be combined with a variety of orchestra conductor desks
- The stand is stable and robust through its:
-
high quality materials and excellent workmanship and
-
particularly strong tube combination 42/35 mm
- The extension tube height adjustment with fine graduation is doubly secure
- Data: Height 845, 885, ... 1325, 1365 mm, base circumference ø 730 mm,
-
weight 4.2 kg
- Fits the K&M orchestra conductor desks and score trays
-
13232 through 12338
SAFETY NOTES
Thank you for choosing this product. The instructions provide directions to all of the important set up
and handling steps. We recommend you keep these instructions for future reference.
- Careful and attentive handling is required when adjusting the stand
-
due to the possibility of pinching or wedging your hand.
- The floor must be suitable, i.e. load bearing and even.
- The maximum stability is achieved when the base struts
1.3
-
of the stand are level
- After completing the height adjustment, the catch
3.4
-
must be clicked into place
3.5
and properly tightened.
- Prior and after use the stand should undergo visual inspection and function to
-
ensure that all components are there and to the extent possible in working order.
- Damaged stands may either not be used i.e. must undergo a repair by a
-
qualified technician.
- The stands are only for indoor use.
1. ASSEMBLE THE STAND
3. ORCHESTRA CONDUCTOR DESKS
SETUP INSTRUCTIONS
1. ASSEMBLE THE STAND
Setting up the 12331 Orchestra conductor stand base is very easy.
All components are pre-assembled.
All that needs to be done is to place the stand in position.
1.1
Loosen the clamping screw of the triangular clamp/bracket a bit.
1.2
Expand the legs until...
1.3
...the connecting struts are level.
1.4
Re-tighten the lower clamping screw.
1.4
NOTE:
1.4
Manual strength is sufficient; avoid over-tightening,
1.4
it places undue stress on the components.
2. ORCHESTRA CONDUCTOR DESKS
2.1.a
Order-No. 12332
beech nature
2.1.b
Order-No. 12333
beech black
2.2.a
Order-No. 12334
beech nature
with shelves
2.2.b
Order-No. 12335
beech black
with shelves
2.3
Order-No. 12338
beech black
extendable
2.4
The plates come with 4 screw sets, consisting of:
3.4
1.
Carriage bolt M5 x 20 mm -
2.
Safety nut M5
3.4
3.
Allen wrench / Hexagon SW8/SW13 -
4.
Protective cap SW8
2.5 a.
Place carriage bolts in the 4 drill holes on the conductor desk plate;
3.5
b.
place this into the joint plate
x
and...
3.5
c.
...connect to the safety nut.
3.5
d.
In the final step put the caps on.
