3.) Attaching the tray to the DJ desk.
4.) Adjusting the tray.
1
Insert the adapter into the clamping
prisms in such a way that the screw
head on the one side and the nut of the
DJ desk are inserted into the openings
in the adapters.
2
Place the extension tube with the
adapter inserted up to the desired leg of
the desk.
The adapters must be placed flat
against the desk leg. Push the carriage
bolts through the clamping prism of the
extension tube. With the slits facing downward, push the clamping bracket over the carriage bolts
from the opposite side and tighten evenly with the locking nuts.
Adjusting the height: Open clamping screw
1
,
set the tray to the desired height, and re-
screw the clamping screw so it is hand-tight.
Adjusting the inclination: Open clamping
screw
2
, set the tray to the desired inclina-
tion, and re-screw the clamping screw so it is
hand-tight.
Aligning the tray plate: Open clamping screw
3
,
turn the tray to the desired position, and re-
screw the clamping screw so it is hand-tight.
Adjusting the extension: Open clamping
screw
4
, move the extension to the desired
position, and re-screw the clamping screw so
it is hand-tight.
Note: Enlarging the extension may cause the DJ desk to tip. Exercise caution when adjusting the
extension and placing equipment on the tray.
Notes: Open clamping screw
2
at least 1.5 turns so that the locking discs are no longer touching
as you ad-just the position. When screwing the screw into place, be sure the teeth of the locking
discs interlock.
Inclination is permitted during use only in the range shown. The tray plate can be folded entirely
to the back for transportation or storage.
1
Push the extension tube with clamping
prism onto the bolt of the holder tube.
The bolt must be fully inserted into the
extension tube.
2
Screw the set screw in until it touches
and then unscrew a quarter turn.
3
The clamping screw can be used to
clamp the set position into place.
