Konica Minolta PULSOX-300, Short Form Instruction Manual, Page: 17 / 56

E 3
English
2 Insert the battery into the battery compartment according to the polar-
ity mark( ) shown on the rear of the instrument.
◆
This instrument requires one AAA-size battery.
3 Turn the battery cover counter-clockwise approximately 90 degrees to
close it.
◆
Introduction of a new mechanism locks the cover automatically when
it is closed.
3. MEASUREMENT
1) Starting the Measurement
1 Attach the probe to a finger of an adult patient.
2 Press the Power button.
●
The Power is switched ON, all the elements on the display are
displayed for about 2 seconds, and then the display changes to the
measurement display.
◆
Until the measurement value has been calculated and displayed,
"---" will be displayed as the values of the oxygen saturation (SpO
2
)
and the pulse rate.
2) Reading the display
When the instrument is turned ON, all the elements of the LED will light
up.
The pulse level, pulse rate and SpO
2
value are displayed during mea-
surement.
3) Ending the Measurement
Press the Power button, the measurement is finished and the Power is
off.
About Auto Power-Off function
The instrument has an auto power-off function that operates indepen-
dently. If no probe is connected to the PULSOX ("C" blinks) or no probe
is attached to the patient ("L" blinks) continuously for more than 2 min-
utes, the Power is automatically switched off.