
LEDs (Light Emitting Diodes)
Version 2.0.1 - 18
IP Controller Board LED's
LED
Status
Display
RS232
Connection between card reader and
IP Controller board.
Off
Card reader (that does not allow
access actively), sends data to the IP
controller board. *1
On
RUN
Running OK
Blink every
0.5 sec.
CARD
Card present
On
Card not present
Off
Card reader cannot be actively
accessed *1
The card data was presented to the
server 2 seconds ago.
ETH Green
Running OK
On
ETH Orange
Running OK
Blinking
Footnotes:
*1.There are card readers that have a protocol installed where the controller board does
not have to establish an active connection with the card reader. The card reader itself
will generate a data string containing the card number. The IP controller board will
receive this data string and, after encryption, redirect this data to the server. This
situation can cause the CARD LED and the RS232 LED to behave differently.
Summary of Contents for inpro
