HT-502
– 3 –
■
Removal of the Power Supply Unit Harness
■
Installing the Dehumidifier Heater
1. Remove two screws from the power box
and remove the cover.
4004U001AA
2. Remove the harness at power feed from
the edge cover and unplug the connector
from the board.
3. Install the cover using the two screws.
4004U002AA
1. Cut off the code cover at rear side of the
paper feeder unit with nipper.
NOTE
This step is not necessary when install-
ing the dehumidifier heater onto the
desk.
4021U014AA
2. Place the dehumidifier heater on top of
the paper feed unit/desk, and then secure
it with the screws.
NOTE
Different types of screws are to be
used between when attaching the
dehumidifier heater to the paper feed
unit and when attaching it to the desk.
<When attaching the dehumidifier heater
to the paper feed unit>
(1) Use four screws A to secure the
dehumidifier heater to the paper feed
unit.
4021U015AA
(2) Pass the cord for the dehumidifier
heater through the notch made in step
1.
C4004U311AA
4034-7190-01E.fm 3
ページ
２００５年３月１８日 金曜日 午後１２時５９分
