FS-501
– 5 –
■
Unpacking the Horizontal Transport Unit
■
Installing the Horizontal Transport Unit
■
Adjusting the Height and Tilt of the Finisher
Remove all packing materials and tape.
C4651U023AB
Tape
1. Place the horizontal transport unit on the
paper output section of the machine, and
make sure that the plastic guide pin on the
bottom of the horizontal transport unit hooks
into the bracket on the finisher.
C4683U023AA
2. Push the horizontal transport unit in.
NOTE
Make sure that the gears on the horizontal
transport unit and on the finisher are
correctly aligned.
C4683U014AA
3. Secure the horizontal transport unit with the
lock.
NOTE
Firmly secure the Horizontal Transport Unit
and the Finisher in position using the Lock
Lever.
C4683U013AA
1. If the finisher gradually tilts toward the
machine, check the following:
•
Are the stabilizing pin and the hole in the fin-
isher at the same height?
•
Is the horizontal transport unit not extremely
tilted?
*
If the finisher is not at the same height as the
machine, adjust the machine as follows.
4684U066AA
2. Slide the finisher away from the machine,
and then remove the lower-front cover (two
screws) of the finisher.
4643U021AB
3. Lift the finisher’s two caster covers up, and
then pull them off.
4643U020AA
