Konica Minolta CS-7, Operation Manual

Page: 271 / 424

271
7.8 CR stitching cassette exposure
Chapter 7
1
Focus on Exam. Tags to register the CR
stitching cassette .
2
Read the barcode of the CR stitching cas -
sette with a barcode reader .
• The barcode number read is displayed in the
Exam. Tag display area. This completes the
read preparation for REGIUS .
3
Perform exposure with the registered CR
stitching cassette .
• Configure the X-ray device settings and check
the exposure setting before making an exposure.
Press the exposure switch
4
Set the REGIUS plate on the read cassette
and read by REGIUS.
• The image read from the barcode on the CR
stitching cassette will be displayed .
7 .8 .3 Image combination
Images exposed by CR stitching cassette can be com -
bined automatically or manually . The procedure below
explains an example of combining 3 images.
IMPORTANT •••••••••••••••••••••••••••••••••••••
• Adjust the combination position by using the markers
as supplementary standards in addition to body parts
of the subject .
It is also recommended that you arrange the measure
in the combined image part during exposure to sim -
plify the confirmation of the combined parts.
• In stitching exposure, when plates overlap and are ar -
ranged so that there is no image loss in each plate's
boundaries, there might be a slight gap in the marker
position because of a minute difference in magnifica -
tion. After taking this into account, confirm the combi -
nation position through the marker .
•••••••••••••••••••••••••••••••••••••••••••••••••••••
1
Select the images to be combined .
• Select the images to be combined from the or-
der list and press [ ] or [ ].
• The selected images are displayed in the com-
bined image display area .
• If you pressed [ ], continuously select the
associated images (second and third) .
HINT •••••••••••••••••••••••••••••••••••••
• [ ] and [ ] can be pressed only when the
Exam. Tag for stitching exposure has been selected.
•••••••••••••••••••••••••••••••••••••••••••••••••••••