Konica Minolta bizhub 43, Service Manual

Page: 124 / 232

- 44 - MG 3000329394 - 03
- Unscew a little bit the scew A and B.
- Push the motor in direction showed by the red arrow and screw B.
- Unscrew the tension motor frame assy (torx 10).
- Remove the tension motor frame from the ADF module.
- Place the belt on the "Gear pulley 19-45-75T".
- Assembly the tension motor frame assy and place the belt on the motor gear.
- Fix the "Tension motor frame assy" on the gear frame with three "Silent bloc Screws".
- Unscrew a little bit the screw A.
- Unscrew the screw B until the belt is set.
- Screw on the screw B and then the screw A.
Caution - Don’t forget to block the motor position. The lack of this step can damage the belt quickly.
• ADF feeder cover
- Unscrew the five screws holding the ADF feeder cover.
D12
OBJECT: ADF
MODULE UNIT
, ADF
FEEDER COVER AND
ADF
MOTOR
(
CONTINUED
)