Konica Minolta 0902, Service Manual

Page: 243 / 302

Chapter 5 Disassembly and Assembly
5-123
9
If the first front back panel was removed, see "
Installation Procedures (Page 5-8)" in "5.2.3
Removing/Installing the Exterior Panel and
Insertion Unit"
to install it.
Now, you have finished with the procedures to replace the transporter read sensor.
5.10.6 Replacing the Transporter Motor
This section describes the instructions on how to replace the transporter motor.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
Shown below are the tools requiring to be prepared in addition to the standard tools before performing the
works in this section.
1
See " Removal Procedures (Page 5-6)" in "5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit" to remove the exterior panel and insertion unit.
2
Remove the exterior frame (back).
•
9 screws (M4 x 8)
3
Rotate the shaft clockwise and move the push
plate unit to the vicinity of the transporter home
position.
This work is intended for the case that the push plate is
at the read position.
1. Move the optical unit to the second front back side.
2. Rotate the shaft clockwise and move to the vicinity of
the transporter home position.
Caution
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
Personnel
Number
Work Hours (steps 2 to 18)
1
No. Tool No. Tool
1 Grease (Plusguard No. 2 by Kyodo Yushi) 2 Waste cloth (used for greasing)
3 Wiring band
First Front Back Side
First Front Back Side