Chapter 5 Disassembly and Assembly
5-107
6
Connect the cables removed in
analog power supply.
•
CN1 (JP24: cable)
•
CN2 (JP27: cable)
7
See
to install the bracket.
•
2 hex/Phillips-head screws (M3 x 6)
8
Install the electric component mount panel that
was removed in
•
8 hex/Phillips-head screws (M4 x 8)
9
Installation Procedures (Page 5-8)"
"5.2.3 Removing/Installing the Exterior Panel
to install the first front panel.
Now, you have finished with the procedures to replace the analog power supply.
5.9.11 Replacing the Digital Power Supply
This section describes the instructions on how to replace the digital power supply.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
The works in this section can be performed using only the standard tools.
1
Removal Procedures (Page 5-6)"
"5.2.3 Removing/Installing the Exterior Panel and
to remove the first front panel.
2
Remove the electric component mount panel.
•
8 hex/Phillips-head screws (M4 x 8)
Loosen all screws.
Caution
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
Personnel
Number
Work Hours (steps 2 to 7)
1
First Front Side
Summary of Contents for 0902
