Kongsberg EM 2040C, Maintenance Manual

Page: 45 / 124

378511/A
43
Read this first
Detailed information about cable specifications, termination and connectors is provided.
Unless otherwise specified, all cables are supplied by Kongsberg Maritime as a part of
the EM 2040C delivery.
Note
All electronic installations and corresponding wiring must be in accordance with the
vessel's national registry and corresponding maritime authority and/or classification
society. If no such guidelines exist, we recommend that Det Norske Veritas (DNV GL)
Report No. 80-P008 "Guidelines for Installation and Proposal for Test of Equipment"
is used as a guide.
Only trained and authorized personnel can install the EM 2040C cables.
Kongsberg Maritime will not accept any responsibility for errors, malfunctions or
damage to system or personnel caused by improper wiring.
A detailed drawing for each specific cable is provided. Each drawing provides additional
information, and may, when applicable, include minimum specifications, connector
terminations and the required number of cores.
Drawings are generally not provided for standard commercial cables.
Cables fall into two categories.
1
System cables
These cables are provided by Kongsberg Maritime as a part of the EM 2040C
delivery.
2
Shipyard cables
These cables must be provided by the shipyard performing the installation, or
the shipowner. It is very important that the cables used meet the minimum
specifications provided in this manual.
Note
It is very important that all cables are properly installed and correctly terminated.
Observe the relevant regulations and work standards. Always leave enough cable slack
close to system units and cabinets to allow for maintenance.
Cable layout and interconnections