Kongsberg EM 122, Installation Manual

Page: 51 / 154

System units
Procedures
How to mount the Preamplifier Unit cabinet
Caution
Always check on the other side of the bulkhead before drilling holes!
1 Mark the location of the holes for the first shock absorber on the bulkhead.
2 Drill 11– mm holes, eight (8) for each shock absorber
3
Mount the complete unit on the bulkhead.
• Use 10– mm bolts, maximum torque 64 Nm.
How to mount the AC cable entry (supply voltage)
1 Insert the AC plug into the socket.
How to mount the Transducer array cables and interfaces
1 Prepare the support bracket to receive the transducer array cables on the lower
frame on the rear side.
2 Mount the cables according to the cable plan.
3 Close and secure cable bracket to secure the cables.
4
Secure the interface cables by strapping them to the transducer cables.
317669/B
49