Kongsberg cNODE MiniS LF, Instruction Manual

Page: 25 / 56

458122/B
25
Replacing the connector
The connector kit consists of a connector, a receptacle, crimp terminals and a cable
sleeve.
Context
Cable specifications
This is the Molex plug seen from the back where the crimp terminals are installed and a
face view of the connector.
Procedure
1 Remove the transducer.
2 Disconnect the transducer cable(s).
3 Disconnect the connector plug from the PCB.
4 Remove the battery and the PCB.
5 Cut the Molex plug.
6 Use a wrench to remove the connector.
Use a wrench with a slim 20 mm socket. The outer diameter of the socket should be
24 mm or less to avoid damaging the transponder housing.
Maintenance