10
Dual Channel Mode:
Data or fax calls will be made with your modem, fax/modem or fax machine (analog
equipment). The call is made by the analog equipment the same way as if it were
connected to an analog phone jack, you would use the communication software to place
the call. If you have to dial a prefix such as a 9 or some other number(s) to make an
outside call on the telephone, you must program that prefix in your communication
software. See your communication software manual for instructions on the use of a dial
prefix.
The digital telephone set can be used simultaneously with the analog device.
!
The device connected to the Analog Modem jack must be configured for tone dialing.
The DWIatt2 will not recognize pulse or rotary dialing.
Using The DWIatt2 for Contact Management Applications
When using the DWIatt2 in conjunction with Contact Management applications follow
the procedure below:
Single Channel Mode:
1.
Leave your digital telephone set on hook.
2.
Command your contact management software to dial the contacts phone number.
3.
After the software has dialed the number, lift the handset of the digital telephone
from the cradle (take the telephone off hook) and issue a quit or hang up command
to the modem through the communication software. You will now be able to carry on
a voice conversation with the party you called.
!
Some contact management software will have
you click the "OK" box or some other
icon/box to hang up the modem.
Dual Channel Mode:
1.
Configure your dialing software to dial a flash hook symbol (!) and a wait symbol (w)
or comma (,) as the first two digits dialed.
Example:
ATDT !w 9w 1800-555-1212
would dial 1800-555-1212 assuming 9 is the trunk access code. If w is not
supported by the modem then , (comma) could be used instead.
ATDT
!,9,1800-555-1212
2.
Leave your digital telephone set on hook.
3.
Command your contact management software to dial the contacts phone number.
4.
After the software has dialed the number, lift the handset of the digital telephone
from the cradle (take the telephone off hook) and issue a quit or hang up command
to the modem through the communication software. You will now be able to carry on
a voice conversation with the party you called.
!
Some contact management software will have
you click the "OK" box or some other
icon/box to hang up the modem.
