12
6-1 – Checking the Game at start up
S
When the game is first turned ON after the installation of the machine, the self
diagnostic test will begin. The test results will be displayed on the screen. If the power
is not turned ON, make sure that the main power switch is in the ON position.
S
Results of power up tests ---------------------------------------------
S
Setting the time ---------------------------------------------------------
If the timer is not yet set in the “Clock”, the following message appears on the screen.
Press the test button, and the “Main Menu” screen shows up instead in the test mode.
Select the “Clock” screen and set the time. Without this setting, the above message
appears each time the machine starts.
S
Gun calibration setting--------------------------------------------------
If the gun has not been calibrated in the “Gun Check” section in the set-up and
diagnostics menu the following message appears in the screen. (The gun calibration is
made at the time of shipment so the message should not appear)
When the test button is pressed at this time, the menu changes to “Main Menu” of the
“Test Mode”. Then, calibrate the gun using the “Gun Check” of the “I/O” check menu. If
the gun calibration has not yet been completed, the above message appears whenever the
game is started.
•
Do not change the DIP switch setting of this machine to anything other than the
factory settings. There are no operator adjustments using the DIP switches.
•
If the game fails to function properly, immediately turn off the main power switch,
unplug the power cord from the receptacle and contact your local distributor.
If the test is OK
– The machine goes to the demonstration mode and the attract mode
begins.
If the test fails
– If “BAD” or “Error” appears on the screen, take proper measures, referring
to the Trouble shooting section on page 26.
PLEASE SET THE CLOCK BEFORE OPERATION
PRESS TEST BUTTON = MAIN MENU
PLEASE CALIBRATE GUN.
PRESS TEST BUTTON = MAIN MENU
17
Adjusting the screen distortion
S
Mode for checking the screen.
Adjust the vertical and horizontal picture size, as required, using the test screen
crosshatch pattern. Use the monitor adjustment PCB to make the adjustments.
To return to the “MAIN MENU” screen, press the start button for player 1.
Adjusting the color display
S
Mode for checking the color display
Adjust the monitor using the monitor adjustment PCB so that the colors of the color
bars in the monitor crosshatch are white, and the background color is dark.
Checking the content of ROM
S
Mode for checking the memory card ROM.
Check the memory card (ROM) which is located in the main PCB unit. “OK” appears
when the board is working normally and “BAD” appears when there is a
malfunction.
Press the player 1 start button to interrupt the ROM check or return to the main menu.
When the ROM check has completed, and passes the tested, “OK” appears.
Screen Check
COLOR CHECK
ROM CHECK
OK