Konami DanceDanceRevolution, Operator'S Manual

Page: 19 / 66

17
FLASH ROM CHECK
Mode for checking the FLASH-ROM. In this mode, the FLASH-ROMs in PCB unit
is checked one by one. When a ROM is normal, "OK" is indicated, and if an abnormal
ROM is found, “BAD” is indicated.
When the question “DO YOU WANT TO CHECK FLASH ROM ? YES/NO” appears, press
the 1P select button to select “YES” or “NO” and press the 1P start button for entry.
When “YES” is selected, FLASH-ROM checking starts automatically. It takes about
40 sec. for checking.
To return to the main menu screen, press the 1P start button. (The game can be
interrupted at any time during a play.)
•If “BAD” is indicated, immediately turn OFF the power switch, unplug the power
cable and contact your nearby “Konami Service Center”.
COLOR CHECK
Mode for checking the display color.
Make the adjustment using the monitor adjustment PCB (See page 48) so that the
colors of the color bars should appear properly graduated and the background should
become black sufficiently.
To return to the main menu screen, press the 1P start button.
Adjusting the display color
5 Game settings
DIP SWITCH CHECK
Mode for checking the setting of the DIP switches.
Be sure to set the DIP switches as follows.
To return to the main menu screen, press the 1P start button.
Indicationing the DIP switch settings
•Since the DIP switches have been set in the status shown
in figure. at left at the time of shipment, the game starts
simply by pressing the power switch. If the bit No. 4 is
turned “ON”, the game will not start even by pressing
the power switch.
MEMO
•This screen is just an example.
DIP switch bit No.
1 2 3 4
OFF OFF OFF OFF
SW 1 2 3 4
0 0 0 0 OFF
ON
TO MODIFY SETTINGS, OPERATE
THE RELEVANT DIP SWITCH
ON THE PCB.
SW1 NOT USE
SW2 NOT USE
SW3 NOT USE
SW4 BOOT DEVICE
CD - ROM
DIP SWITCH CHECK
PRESS 1P START BUTTON = EXIT
Showing a current position of each DIP switch.
(The figure shows that all the DIP switches are set to OFF.)
The DIP switch 1 is not used.
Keep it to OFF.
The DIP switch 2 is not used.
Keep it to OFF.
The DIP switch 3 is not used.
Keep it to OFF.
Keep the DIP switch 4 to OFF.
When it is set to OFF, “CD-ROM” appears on the screen.
Checking the content of the FLASH-ROM in PCB unit