- 3 -
Risk of burns!
The hydraulic dampers become hot during training.
You must never touch them, and not directly after
training either.
Risks due to incorrect/
excessive training!
Please make absolutely sure you follow all the in-
structions contained in the chapter entitled „Training
instructions“ from page 6 onwards.
Caution!
It is possible that oil could escape due to leakage of
the hydraulic dampers. To avoid soiling of the floor
or carpet, place the device on a level, non-slip un-
derlay.
Prevent liquids from entering the computer. The sen-
sitive electronics could get damaged. Protect the
computer against direct sunlight.
Never use force when handling the device.
Check regularly that all the screws, nuts and bolts
are tight. Self-locking nuts cannot come loose due to
vibrations. This feature, however, can only be guar-
anteed the first time the nuts are tightened.
If the stepper is ever disassembled, all the self-lok-
king nuts must be replaced with new ones.
If you do not need to use the device for a longer pe-
riod of time, remove the battery from the computer
or else it could leak and cause damage.
Assembling and setting up
Most of the device is supplied pre-assembled. Only a
few things need to be done in order to make it ready
for use.You will need a Phillips type screwdriver
(supplied).
1. Insert the two plastic feet
q
into the rear floor
tube
w
If necessary, rotate the foot
q
until the
slot fits into the recess of the floor tube
w
.
2. Screw the self-tapping screws
e
into the pre-dril-
led holes on the underside of the floor tube
w
.
3. Screw the adjusting screw
r
into the thread on
the front frame.
r
q
w
e
IB_KH6002_UL33095_3B_C 07.04.2009 15:19 Uhr Seite 3