Kompernass E-4038, Operating Instructions Manual

Page: 72 / 100

 | Operating Instructions
IRL
Operating Instructions| 
IRL
. Safety Instructions
Attention!
Never have the water pump, the halogen lamp with the
rotating colour disc and the mist generator switched on for
more than 8 hours continuous operation; this may cause
overheating to damage the electrical units. After an oper-
ating period of more than 7 hours, please wait for a min.
cooling period of 1 hour before starting again.
Never leave the natural-stone fountain unattended during
operation, this to ensure that in the case of malfunctions the
power supply is disconnected and damages are avoided
to the water pump! Do not use your Natural-stone water
fountain on a low water level. Make sure that the pump will
always be covered by water.
If the water basin has a low water level and the pump is not
completely covered by water while the natural-stone foun-
tain is in operation, please unplug the transformer and fill
the water basin with distilled water up to the “MAX” mark
before starting again.
. Adjusting pumping rate and water flow
Pumping rate of the water pump is variable in three steps and
allows to adjust higher or lower water flow when the natural-
stone water fountain is in operation.
To adjust the pumping rate ...
 Unplug the transformer.
 Remove the decorative stones from the water basin.
 Remove the L-hose joining piece at the end of the hose con-
necting piece from the plug adaptor of the water pump.
 Take the water pump out of the water.
Attention!
Never leave the natural-stone fountain unattended during
operation, this to ensure that in the case of malfunctions the
power supply is disconnected. It is most important to check
the water level in the water basin during operation!
A low water level may cause overheating to damage the
water pump!
If the natural water pump is in operation and the water level
in the water basin is too low, overheating may cause damage