If Using Duotight Push To Connect Fittings:
Remove nut and barb from the regulator and replace with Duotight fitting. Then tighten by
hand an additional 180° turn. Push gas line into Duotight fitting and pull back on tubing slightly
to ensure connection. (See Photo Below).
If Using Stepless Clamps:
Dip tubing in very hot water for 15 seconds to soften. Place stepless clamp onto tubing. Insert
needle-nose pliers into tubing and expand the pliers. Connect to the barbed on your regulator.
Crimp clamp securely onto tubing. (See Photo Below).
Remaining Steps:
1.
Attach the regulator to the tank using the included multipurpose wrench.
2.
Tighten firmly, but be careful not to over tighten. NOTE - there must be a regulator gasket between the regulator
and tank. Some regulators come with a gasket already attached to the regulator.
3.
Using the provided CO
2
tank strap, attach one end to the fixing hook inside the kegerator. Place the CO
2
tank on
its shelf in the right hand corner of the kegerator. (See Photo Below).
4.
Once CO
2
tank is in place, attach the remaining end of the tank strap to remaining fixing hook. (See Photo Below).
We recommend you attach the tubing to the regulator prior to connecting it to the tank. There are
two ways to connect your CO
2
regulator. We strongly recommend using a Duotight push-to-connect
fitting which is designed to work the EVA Barrier line that is included with your KOMOS Kegerator.
9
:
Connecting The Gas Line & CO
2
Regulator To The Tank:
DUOTIGHT
CLAMP
3.
4.
DUOTIGHT
FITTING
STEPLESS
CLAMP
