Page 18 Komfi Rider Skippa
● Maintenance
1
．
Regularly check all wiring connections. Regularly check all wiring insulation, including
the charger power cord, for wear or damage. Have your authorized Provider repair or
replace any damaged connector, connection, or insulation that you find before using
your Travel Scooter again
2
．
You should keep electrical connections away from sources of dampness, including
direct exposure to water or bodily fluids and incontinence. Check electrical components
frequently for signs of corrosion and replace as necessary.
3
．
Use a damp cloth and mild, non-abrasive cleanser to clean the plastic and metal
parts of your Travel Scooter. Avoid using products that may scratch the surface of your
Travel Scooter. If necessary, clean your product with an approved disinfectant. Make
sure the disinfectant is safe for use on your product before application.
DISPOSAL OF YOUR SCOOTER
Your Scooter must be disposed of according to applicable local and national statutory
regulations. Contact your local waste disposal agency or authorized service centre for
information on proper disposal of packaging, metal frame components, plastic components,
electronics, and batteries.
IX. FAULT DIAGNOSIS
DIAGNOSTIC FLASH CODES
The diagnostic flash codes for your Travel Scooter are designed to help you perform basic
troubleshooting quickly and easily. A diagnostic flash code will sound in the event one of the
conditions listed below develops. Depending on the model you own, your Travel Scooter will
communicate by one of the coding methods as follows:
1.
A flash code will begin with a series of fast flashes directly followed by slower flashes
which indicates the actual code. The flash code is only flashed once. To repeat the flash
code, remove the key, then reinsert it and turn it to the “on” position,
OR
2.
A flash code will identify the condition, pause, then repeat the flash code. The flash code
will continue to alert you in this manner until the scooter is turned off.
NOTE: Your Travel Scooter will not run unless the flash code condition is resolved and the
Travel Scooter has been turned off, then turned back on
