20
KOMET
MicroKom
BluFlex® 2
5
7
2
6
J
9
8
3
1
4
1
Micro-adjustable head with ABS50 connection
2
Slide
3
Clamping screw for slide
4
Adjusting screw for slide
5
Coolant outlet (see page 27)
6
Balance compensation
7
Battery compartment
8
9
Screws for tool clamp
(see page 26)
J
Touch display and confirmation
- Fit boring bars, serrated bodies or bridges with cutting edge holders and
inserts with the
MicroKom
BluFlex
® 2
precision adjustment head.
- Always use the specified tightening torques
The tool is usually operated as follows:
- Before adjusting the slide, loosen the clam-
ping screw, adjust the slide, release the
tension slightly and then clamp.
Note: Always use a clamping torque of 8 Nm.
- Preset the cutting edge position in absolute
mode
- Adjust the premachining diameter on the
tool presetting device
- Always put all the screws in lightly (risk of
flying off)
- Always remove the adjustable spanner and
clamping spanner after adjustment and
before start-up
- Make the hole
- Measure
- Set precision adjustment in difference mode
