Check the guitar cables and signal patch cables.
Bypass all effects from pedal board and connect only one pedal from pedal board and test
AmbiKab
. If the AmbiKab
functions with just one pedal, then it is operational. Thoroughly
check your pedal board connections and set your pedal board up through the AmbiKab
again.
Removing Back Panel:
Please be very careful when removing the back panel for any inspection. The speaker harness
wiring will only allow you to open the panel a few inches. You will have to un-plug
four
harness connections so as to remove the back panel so you can easily have access your speakers.
We recommend that you (very carefully) unscrew the input nut (on the speaker input) with a 1/2”
nut driver. This will release the Switchcraft ¼” jack from the panel. You will also have to
manually remove the red and black terminal wires (which are also attached to the input jack)
from the power board. Then un-plug the two remaining 10” speaker wiring harnesses from the
pre amp board. Make sure you re-install them all correctly when done. If not, your cabinet will
be out of phase.
ALWAYS
make sure the IEC power cable is not plugged into the AC input
when opening the back panel.
SPECIFICATIONS
• Dimensions
: 30" x 11.50 x 26.50
• Weight
:
75 lbs.
• Speakers
: two -12” Celestion speakers and two 10” Celestion speakers.
• Power
:
80 Watts RMS
(standard setup) 100 Watts plus depending on speaker selection.
CONTACT
Komet
Amplification
1865 Dallas Drive
Baton Rouge, LA 70806-1454
(225) 926-1976
Email:
Website:
www.kometamps.com
Facebook:
https://www.facebook.com/pages/Komet-Amplification/739410886107995
Tumbler:
http://kometamplification.tumblr.com/
Twitter:
https://twitter.com/kometamps
Copyright 1999-2017, Komet
Amplification. Group, L.L.C. May not be reproduced in any form without express written consent from Komet
Amplification
