Kolpa Kolpa-San ZEPHYR 1680 3F, Manual

Page: 10 / 40

9
www.kolpasan.eu
massage cab is not allowed to have access to any parts containing live parts,
except those supplied with safety extra-low voltage (SELV) not exceeding 12 V.
o
Children are allowed to use the appliance without supervision only if
instructed on the safe use massage showers, and if they understand the
potential dangers in the event of improper use.
o
The device may only be connected to the mains electricity which is protected
by means of a fault current protection switch FID
IΔN

30 mA. The FID switch
is designed to interrupt the phase conductor and the zero conductor in cases
when the current flowing into the switch along the phase conductor is not the
same as the one flowing out along the zero conductor.
o
The massage shower enclosure must be permanently connected to the power
supply network, i.e. plugging it into a socket is PROHIBITED. In addition, it
must be possible to switch off this circuit with a multipole switch. The device
enabling the separation of all poles from the power supply network must be
integrated within the electrical wiring in line with the national wiring-related
regulations.
o
The cable entry must be protected with a 16A safety fuse (3.5kW). Conductor
cross-section = 2.5 mm
2
.
o
The device may only be plugged into the mains electricity if furnished with a
ballast that disconnects the phase conductor and the zero conductor from the
device.
o
The manufacturer or repairer of this device (i.e. the massage shower
enclosure) is not responsible for the installation and proper functioning of both
switches, i.e. FID and ballast.
o
The additional earth conductor (cross-section = 6 mm
2
) must be
connected to the connection point for equipotential bonding, which is
marked with the symbol shown on the right:
o
While the steam bath is on, all parts of the person’s body must be at least 15
cm away from the outgoing steam nozzle in order to avoid the risk of getting
burned.
o
The continuous-flow water heater decreases the flow of hot water. Due to the
different pressure of hot and cold water, the proper functioning of the water
mixer is impeded. In such cases, no complaints on the grounds of improper
mixer functioning shall be acknowledged.
o
The low flow of water or the simultaneous use of several massage functions
will decrease the effect (i.e. the intensity) of the massage jet nozzles.
o
The massage shower enclosure may be connected to the water supply with a
minimum pressure of 0.2 MPa (2 bar) or a maximum pressure of 0.4 MPa (4
bar). Connecting it to higher water pressure is prohibited without installing an
additional device intended to limit the water pressure and set at 0.4 MPa (4
bar). Kolpa d.d. shall not acknowledge complaints arising from the use of
water pressure that is higher than allowed for this product.
o
The parts which contain electrical components (with the exception of remote
controls) must be set or affixed in a way that prevents them from falling into
the bathtub. The parts that contain components under voltage, with the
exception of parts under safety extra low voltage (SELV) that does not exceed
12 V, may not be accessible to the person in the massage shower enclosure.
o
Certain parts of the massage shower enclosure feature surfaces
that heat up to such an extent that they can cause burns in the
event of direct contact or lengthy exposure at a distance of 10 to
15 cm. Such surfaces feature a symbol shown on the right.