Kollmorgen MMC Smart Drive Series, Hardware Manual

Page: 249 / 386

Kollmorgen - June 2014 247
MMC Smart Drive Hardware Manual
-
460V 3-PHASE MMC SMART DRIVE
8.2.5.2 24V Power Connector (J1)
Table 8-20: 460V Size 5 24V Power Connector (J1)
Signal
Type Signal
Description
Pin
Connector
Label
In/Out Connector
Power
24 VDC input
power
1 +24V
In
2 +24V
24V Logic
Input/Out-
put
See footnote
a
a. As an Output, indicates that the AC Input Power to the drive is OK. As an Input,
instructs the drive to run even though AC Input Power is not present. This is typ-
ically used when two drives share bus power that is provided by the drive con-
nected to AC Input Power. See
section A.1 on page 371 for more information.
3 Mains On In/Out
24V Logic
Input/Out-
put
See footnote
b
b. As an Output, indicates that the drive’s Shunt Output is active. As an Input,
instructs the drive to activate its Shunt Output. Whenever the Shunt On signal is
active (24Vdc nominal), the user-supplied shunt resistor (installed between Ba+
and 1C1 (ZK+) is connected across the DC bus. See
section A.1 on page 371
for more information.
4 Shunt On In/Out
Power
24 VDC input
common to the
drive.
5 24V Com
In
6 24V Com
Note: A 6-pin cage-clamp mating connector is included with the drive. Additional
connectors (P/N M.1302.7099) are available from Kollmorgen.
CAUTION
A possible ignition hazard within the MMC 460V Smart Drives exists if exces-
sive current is drawn from the 24 VDC powering the MMC Smart Drive. To
prevent this possibility (due to improper wiring or 24 VDC supply failure), a
fuse should be used in series with the 24 VDC to the MMC Smart Drive. Spe-
cifically, a 4 A max. “UL248 Series” fuse should be used. In addition, the 24
VDC shall be supplied by an isolating source such that the maximum open
circuit voltage available to the MMC Smart Drive is not more than 30 VDC.
+24V
+24V
Mains On
Shunt On
24 Com
24 Com
Top
1
2
3
4
5
6