16
INSTALLATION INSTRUCTIONS
NOTE: Before installing, remove all packaging from inside the carton, along
with any inserts placed into the side louvers.
Select the best location
1. To avoid vibration and noise, make sure the unit is
installed securely and firmly.
2. Install the unit where the sunlight does not shine
directly on the unit. If the unit receives direct
sunlight, build an awning to shade the cabinet.
3. There should be no obstacle, such as a fence or
wall, within 50cm from the back of the cabinet
because it will prevent heat radiation of the
condenser. Restriction of outside air will greatly
reduce the cooling and heating efficiency of the
air conditioner.
4. Install the unit a little obliquely outward not to
leak the condensed water into the room (about
O
3~4 with level).
5. Install the unit with its bottom portion 75~150cm
above the floor level.
6. The power cord must be connected to an
independent circuit. The yellow/green wire must
be grounded.
All side louvers of the cabinet must remain
exposed to the outside of the structure.
CAUTION
75~150cm
Over 50cm
AWNING
FENCE
Suggested tools
1. Screw driver (medium size Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Level gauge
Note: Unit may be supported by a solid frame
from below or by a hanger from a solid
overhead support.
AIR IN
AIR IN
AIR OUT
100mm minimum
OPTION A
AIR IN
LOUVRE
BRICK
WALL
O
45 BRICK CUT AWAY
TO CLEAR LOUVRES
FRONT
AIR OUT
AIR IN
AIR IN
TOP
VIEW
O
45 BRICK CUT AWAY
TO CLEAR LOUVRES
100mm
BRICK
WALL
100mm
OPTION B
Select the best location
Installations of the unit into the wall
O
3~4
NOTE:
After installing,make sure the air conditioner
O
is tilted 3~4 to the outside to allow water drainage
a
nd p erfect c ooling e fficiency.