OPERATING INSTRUCTIONS
15
Operation instructions
Control Panel
The controls featured in this manual are representative
of many available models. Your model may offer slightly
different features.
Cool Mode
The desired cool setting is selected by rotating the knob
to the appropriate location.
HI COOL
has maximum cooling effect and airflow.
LO COOL
has minimum cooling effect and airflow.
Fan Mode
Rotate the knob to select your choice of fan speeds for air
circulation.
NOTE:
When selecting a fan speed, the compressor will
not run.
Thermostat
The thermostat is used to set the desired room tempera-
ture when the unit is being operated in the
COOL MODE
.
TEMPERATURE
min
cool
max
cool
COOLING
1
4
5
6
7
To set the desired room temperature, rotate the thermostat
switch to the desired setting. After the set temperature is
achieved the thermostat will automatically start and stop
the compressor in order to maintain the desired set
temperature.
Rotate the thermostat selector clockwise for higher cool
settings. Higher cool settings will provide lower room
temperature. Rotate the thermostat selector counter
clockwise for lower cool settings. Lower cool settings will
provide higher room temperature.
2
3
lo
fan
lo
cool
hi
cool
hi
fan
OFF
Air Directional Louvers
The louvers will allow you to direct the air flow Left or
Right throughout the room as needed.
Move the Center handle from side to side until the
desired Left/Right direction is obtained.
Air Direction
Please always wait 3 minutes when turning
unit off then on again, and when changing from
cool to fan and back to cool. This prevents
compressor from overheating & possible
circuit breaker tripping.
Center handle(3)
TEMPERATURE
COOLING
Wait Three Minutes Before Restarting
The control panel of the unit you bought may
be look like one of the following:
min
cool
max
cool
6
5
4
3
2
1
7
Low
Fan
Low
Cool
High
Cool
High
Fan
OFF