K3 IMU
- 30 -
§3.4.7 Radio Config
As the name implies, the parameters of radio can be done in “Radio Config”, it is divided into
Radio Parameter and Radio Frequency.
Radio Parameter
This page is mainly used to configure the parameters for internal radio module of KOLIDA K3
IMU.
Air Baud Rate:
This represents the data transmission rate in the air of internal radio, the higher
value, the bigger of data size transmitted per second, usually keep the default setting.
Data Baud Rate:
This represents the rate of data transmission port of internal radio. The rate
should be the same in both Base and Rover. In general, the data baud rate of KOLIDA radio
module has been unified to be 115200, keep it as default.
Channel:
This is the communication channels for internal UHF, the value of the channel must be
the same both in Base and Rover.
Power:
This appears only in Base mode, the radio transmitting power is allowed to define in High,
Middle or Low power.
Protocol:
This is radio communication protocol for data transmission, SOUTH (KOLIDA )
，
Farlink and TRIMTALK are optional in this page and SOUTH is the default setting, if it is
changed, Base and Rover must use the same protocol for communication.
Factory Default:
Click this button to restore the factory default for internal UHF module.
