7
To fill the rinse aid dispenser, unscrew the dispenser cap located on the inner door (or on the back of the tub,
depending on your model). Add the rinse aid slowly into the dispenser until it just reaches the bottom of the
filling cap inside the dispenser opening. Then replace the cap.
Operating Instructions
To operate the dishwasher:
Make sure the inlet and drain hoses are correctly and securely connected.
1.
Push the door release button to open the door.
2.
Check to make sure that the filter (bottom of the machine, above the heating element) is in the right
position.
3.
Place the dishes on the dish rack and the cutlery inside the cutlery basket.
4.
Check to make sure that the rotating spray arm can turn freely all the way around. If necessary,
remove any obstacles.
5.
Fill the detergent in the recessed area on inner door panel. (12g maximum).
6.
Close the door securely
7.
Open the water supply.
8.
Push the power (on/off) button.
o
Button pushed in = power on
o
Button pushed in = power off
The LED display and the power light will illuminate indicating the machine is receiving power.
9.
Select the desired program by press the program button. The LED will display the washing code you
select. The LED will display the default washing mode when it receives power.
o
P1= Intensive Wash
o
P2=Normal Wash
o
P3=Rapid Wash
o
P4= Eco Wash
o
P5=Pre-Wash
10.
Press the start/pause key to start. The LED will flash the program selected and the washing status
during operation.
11.
At the end of the cycle the dishwasher will stop running, the LED will stop flashing, and the dishwasher
will beep. The LED will turn to black (off) when the machine does not run or operate for 10 minutes or
more. The power light will remain illuminated until the power (on/off) button is switched off.
12.
The dishwasher is designed to stop if the door is opened accidentally during operation.
