KOKEN LM-101B, Instruction Manual

Page: 10 / 14

8
3. Place the hook of the placenta model on the string loop of the umbilical cord. Unfold the
edges of the ends that were rolled down so that the end of the umbilical cord of the placenta
model covers the umbilical cord.
*If the umbilical cord is not partially covered by the umbilical cord of the placenta model, they
may come apart during delivery.
*Make sure the parts are not lubricated when attaching them together, as it will be difficult
to slide the umbilical cord of the placenta model over the umbilical cord if they are lubricated
with glycerin or another lubricant during this step.
4. Roll down the end of the umbilical cord connector with a hook attached so that the hook is
visible, then attach the hook to the umbilical ring on the fetal model (LM-0633). After attaching
the hook, unfold the end.
- 7 -
3.
Place the hook of the placenta model on the string loop of the umbilical cord for
tying and cutting. Unfold the edges of the ends that were rolled down so that the end
of the umbilical cord of the placenta model covers the umbilical cord for tying and
cutting.
*If the umbilical cord for tying and cutting is not partially covered by the
umbilical cord of the placenta model, they may come apart during delivery.
*Make sure the parts are not lubricated when attaching them together, as it will
be difficult to slide the umbilical cord of the placenta model over the umbilical
cord for tying and cutting if they are lubricated with glycerin or another
lubricant during this step.
4.
Roll down the end of the umbilical cord connector with a hook attached so that the
hook is visible, then attach the hook to the umbilical ring on the fetal model
(LM-0633). After attaching the hook, unfold the end.
Hook
Umbilical ring
- 7 -
3.
Place the hook of the placenta model on the string loop of the umbilical cord for
tying and cutting. Unfold the edges of the ends that were rolled down so that the end
of the umbilical cord of the placenta model covers the umbilical cord for tying and
cutting.
*If the umbilical cord for tying and cutting is not partially covered by the
umbilical cord of the placenta model, they may come apart during delivery.
*Make sure the parts are not lubricated when attaching them together, as it will
be difficult to slide the umbilical cord of the placenta model over the umbilical
cord for tying and cutting if they are lubricated with glycerin or another
lubricant during this step.
4.
Roll down the end of the umbilical cord connector with a hook attached so that the
hook is visible, then attach the hook to the umbilical ring on the fetal model
(LM-0633). After attaching the hook, unfold the end.
Hook
Umbilical ring