background image

1356428-T01-A

- 5 -

b. Connect the connector on the counter top with that on the cabinet. After the 

counter top is fixed and the silica gel is completely dried, find the connector A1 

on the counter top and the connector B2 on the cabinet and connect them 

together by inserting one into the other. (Make sure the connectors are 

securely connected. Attempt to pull them apart. If they cannot be separated, 

the connection is secure.)

c. Install the washbasin and the counter top: Take out the attached washbasin. 

Place it into the hole in the counter top in the direction shown in the figure 

below (find the washbasin connector A3 shown in the figure below prior to 

placing the washbasin). Slightly turn the washbasin until it cannot be turned 

anymore with uniform gap from the counter top.

b. 

台面和浴柜线路接口连接。固定好台面后,待胶干透后,找到台面上的 A1 和浴

柜上的 B2 接口将他们插入连接起来。(确保插头连接到位,可以试着反方向用

力拔开两个接口,无法拔出则连接到位)

c. 

台盆与台面安装:将配套的台盆取出,按下图所示方向放入浴柜台面上的台盆

孔中(安放台盆前找到图示中所示的台盆接口 A3),放入台盆后轻轻转动台盆

确保台盆稳定不会转动,且与台面的缝隙均匀。

d. Connect the connector on the washbasin and that on the counter top. After 

fixing the washbasin, find the connector A3 on the washbasin and the 

connector B1 on the counter top. Connect them together by inserting one into 

the other. (Make sure the connectors are securely connected. Attempt to pull 

them apart. If they cannot be separated, the connection is secure.)

e. Fix the washbasin: After verifying the washbasin is properly placed, apply silica 

gel into the gap between the washbasin and the counter top (see the figure 

below). Check that the connector on the washbasin is securely connected with 

that on the counter top.

d. 

台盆和台面线路接口连接。固定好台盆后,找到台盆上的 A3 接口和台面上的

B1 接口,将他们插入连接起来。(确保插头连接到位,可以试着反方向用力拔

开两个接口,无法拔出则连接到位)

e. 

固定台盆:确认台盆放置好后,沿台盆与台面一圈接缝处打透明硅胶(见下

图) ;并确认台盆与台面的电线接口是否连接好。

Light Band

Washbasin

台盆

Stone Counter Top

石材台面

Cabinet Panel

浴柜台面板

Area With Silica Gel

台盆一周该间隙处打

透明硅胶

Enlarged Figure Of The Gap Between 

The Washbasin And The Counter Top

台盆与台面间隙处放大图

B1+A3

A1+B2

Enlarged Figure Of The Connector 

Below The Washbasin

台盆底部电线接口放大图

B1

A1+B2

A3

B1

A3

Enlarged Figure Of The Connector 

On The Washbasin

台盆电线接口放大图

Enlarged Figure Of The Connector 

On The Counter Top

台面电线接口放大图

Fig. 7 

7

Fig. 8 

8

Summary of Contents for VEIL K-21800T-X









Reviews: