INSTALLATION
1. Install Supplies
Install the services.
Hot (H) and Cold (C) inlets must be connected to the correct
inlet pipes.
Install the drain in accordance with the manufacturer s
instructions.
We suggest using P-trap drain. Connect P-trap pipe with
washbasin drain.
Make sure a watertight seal exists on all
washbasin drain connections.
Provide access to the plumbing
connections for future plumbing maintenance.
The hot and cold water supplies must be installed with
isolating valves.
CAUTION!
CAUTION!
NOTE:
1.
(H)
(C)
P
-3-
2. Wall Preparation
·
·
Install the water supply and drain lines according to the
roughing-in information provided with your lavatory. The
water supply nipples must extend at least 76mm beyond
the finished wall material.
Complete the finished wall. Make sure the finished wall is
straight and plumb, and the floor is flat and perpendicular
to the finished wall.
Do not install any moldings that may inhibit the
vanity from being plumb against the finished wall.
IMPORTANT!
2.
·
·
76mm
1188934-T01-B
