2. Install the Lavatory
Install the drain to the lavatory according to the manufacturer’s
instructions.
Drill 5/32
″
holes in the center of each mounting hole mark.
CAUTION: Risk of personal injury and product damage.
Support the lavatory during installation. The mounting slots
alone cannot support the lavatory.
Partially install two lag screws and washers into the inside
(bottom) holes drilled in the wall.
Position the lavatory on the lag screws. Support the lavatory
while installing two lag screws and washers through the
remaining holes.
Hand tighten all four lag screws to support the lavatory.
Verify that the lavatory is level. Adjust if needed.
CAUTION: Risk of product damage.
Use extra care to avoid
scratching the lag screw finish when tightening.
CAUTION: Risk of product damage.
Do not overtighten the
hardware. Overtightening may damage the lavatory or finished
wall.
Carefully tighten the lag screws to avoid scratching the finish. Do
not overtighten the screws.
If the lag screw finish becomes damaged during installation,
carefully apply touch-up paint (included) to the lag screw head as
needed. Follow the instructions on the bottle.
Mounting Hole
Locations
Lag Screw
Wall
Washer
Lavatory
Hole
Slot
1036208-2-B
4
Kohler Co.
