Kohler RH255, Service Manual

Page: 48 / 56

48
Reassembly
KohlerEngines.com 18 690 06 Rev. --
Cylinder Head Components
G
H
I
L
N
A
B
C
D
E
F
K
M
O
J
1
3
4 2
1
2
4
3
A Valve Cover B Adjusting Nut C Rocker Arm D Rocker Arm Stud
E Push Rod Guide F Push Rod G Valve Keeper H Valve Spring
I
Intake Valve Stem
Seal
J Cylinder Shroud K Valve L Spark Plug
M Dowel Pins N Cylinder Head O Torque Sequence
NOTE: Before installing fl ywheel make sure crankshaft
taper and fl ywheel hub bore are clean, dry, and
completely free of lubricants. Presence of
lubricants can cause fl ywheel to be over
stressed and damaged when nut is torqued to
speci fi cation.
NOTE: Make sure fl ywheel key is installed properly in
keyway. Flywheel can become cracked or
damaged if key is not installed properly.
1. Install woodruff key into keyway of crankshaft. Be
sure that key is properly seated and parallel with
taper of shaft.
2. Install fl ywheel onto crankshaft, being careful not to
shift position of woodruff key.
3. Install fl ywheel shield and secure with screw.
4. Install fan bosses into matching holes in fl ywheel.
5. Position drive cup on fl ywheel, engaging boss on its
base with corresponding hole on fl ywheel. Hold in
position and install nut. Finger tighten to keep cup
indexed.
6. Use a fl ywheel strap wrench and torque wrench to
tighten fl ywheel nut. Torque nut to 74 N·m
(655 in. lb.).
Install Ignition Module
NOTE: Ensure ignition module is correctly oriented.
1. Turn
fl ywheel so magnet is away from location
where ignition module will be installed.
2. Install ignition module loosely to bosses with screws.
Move module as far away from fl ywheel as possible,
then tighten screws just enough to hold it in position.
3. Rotate fl ywheel in a clockwise direction until magnet
is under 1 leg of ignition module.
4. Insert a 0.254 mm (0.010 in.) fl at feeler gauge
between leg of module and magnet. Loosen nearest
screw, allowing magnet to draw module against
feeler gauge. Push against module to hold leg tight
against feeler gauge while tightening screw.
5. Rotate fl ywheel until magnet is under other leg of
module. Loosen nearest screw, allowing magnet to
draw module against feeler gauge. Push against
module to hold leg tight against feeler gauge while
tightening screw.
6. Torque both module screws to 8 N·m (70.8 in. lb.).
7. Rotate
fl ywheel back and forth, checking to make
sure magnet does not strike module.
8. Connect kill wire to ignition module bottom blade
terminal and route wire lead across top of
crankcase.