9
1333238-W2-A
10.
Only use the inlet connections supplied with the product.
DO NOT
use any
other type of fittings.
11.
DO NOT
overtighten connections, screws or grubscrews as product damage
may occur.
8.
Position the shower unit where the controls are at a convenient height for the
user. Position the showerhead so that the water sprays in line with the bath or
across the opening of a shower cubicle. The installation must not cause the
shower hose to be kinked during normal use or obstruct the use of the control
handles.
9.
The position of the shower unit and hose retaining ring must provide a minimum
air gap of 25 mm between the showerhead and the spill over level of any bath,
shower tray or basin. There must be a minimum distance of 30 mm between
the showerhead and the spill over lever of any toilet, bidet or other appliance
with a Fluid Category 5 backflow risk.
Note!
There will be occasions when the hose retaining ring will not provide a
suitable solution for Fluid Category 3 installations, in these instances an outlet
double checkvalve must be fitted, this will increase the required supply pressure
typically by 10kPa (0.1 bar). Double checkvalves fitted in the inlet supply to
the appliance cause a pressure build up, which affect the maximum static inlet
pressure for the appliance and must not be fitted. For Fluid category 5 double
checkvalves are not suitable.
Zone of
Backflow
Risk
30 mm
Minimum
Toilet or Bidet
FC5
Hand Basin
FC3
Bath or Shower
Tray FC3
Mixer
Shower
25 mm
Minimum
25 mm Minimum
Summary of Contents for Mira Honesty
Page 2: ...2 1333238 W2 A...
Page 19: ...19 1333238 W2 A Notes...
