19
Control Assembly
1.
Pull off the temperature knob.
2.
Carefully separate the concealing plate
from the backplate.
Note!
Use a screwdriver in the cutout
to assist separation.
3
.
Fit the backplate to the shower control
and secure with the three securing
screws (removed from the building-in
shroud). Make sure that the seal is fully
compressed on the finished wall
surface.
Note!
If the finish is particularly uneven
(i.e. due to grout lines), apply a small
amount of silicone sealant to ensure a
seal.
Caution!
Do not overtighten the
screws as this may cause the
backplate to distort, preventing the
fitting of the control knobs.
4.
Align the flow control hub with the taper
towards the top of the shower control
(refer to illustration).
Temperature
Knob
Concealing Plate
Flow Control Hub
Securing Screws
Backplate
(Seal on Rear)
Cutout
