-5-
1426810 -T01-
B
Step 5
Test System
•
Turn on the water filtration faucet.
•
Slowly turn on the cold water supply valve, Run water to
flush trapped air.
NOTE:
It is normal for there to be Residual air in the
System causing bubbles (temporary cloudiness) in the
water.
•
Turn on the cold water supply valve and the water
filtration faucet, run water for a minimum of 20 minutes to
flush, The system installation is now complete and ready
to serve filtered water.
•
Turn off the water filtration faucet, Keep the cold water
supply valve turned on for 10 minutes. Check all fittings
and tubings for leaks. If it leaks, see Troubleshooting.
•
Complete the installation and cleanup.
步骤五：系统测试
•
打开净水龙头。
•
缓慢开启冷水进水阀门，排出空气。
注意：
出水中有一些气泡引起的（暂时的暗色）是由于管
路中的残余空气引起的正常现象。
•
打开净水龙头，持续冲水
20
分钟以上，本系统安装完成可
正常使用。
•
关闭净水龙头后，保持冷水阀门打开，等待10分钟，检查
所有连接部件及管件有没有漏水情况，如有漏水情况，查
看常见故障排除表。
•
完成安装并清理现场。
10min
Flush
冲洗
TROUBLE SHOOTING GUIDE
No.
Symptom
1
2
Probable Cause
Solution
Leaks at quick connect fittings.
Tubing is not pushed to the backstop.
Tubing is not straight and smooth.
Reinsert tubing into push-in fitting as
far as it will go.
Recut tubing.
4
5
6
7
No water flow from the water
filtration faucet.
Water flow from the water filtration
faucet becomes small.
Filtered water tastes strange or like
chlorine bleach.
The main water line valve is closed.
The tubing is crimped or sharp
bended.
The filtration cartridge is blocked.
Service life of carbon block cartridge
runs out.
Check and open it.
Keep the tubing straight.
Replace the cartridge.
Replace the cartridge.
3
Leaks at quick tubing.
Tubing is cracke or scratched
Simply cut that portion away and
reinsert tubing into push-in fitting.
常见问题及处理
1
2
4
5
6
7
3
序号
故障现象
故障原因
解决办法
把软管重新插到底。
把裂开部分切掉重新插入快速接头。
更换滤芯。
更换滤芯。
把软管放直。
打开进水阀。
重新切平。
软管未插紧。
管子端口有毛刺或未切平。
软管有刮伤或裂痕。
进水阀关闭。
软管被弯折。
滤芯长时间堵塞。
活性炭滤芯失效。
快速接头漏水。
软管漏水。
净水龙头不出水。
净水龙头出水变很细小。
经过滤后的水有氯味或者口感有异味。
