65
Disassembly/Inspection and Service
22 690 01 Rev. --
KohlerEngines.com
Remove Stator
A
B
C
D
A
Stator Wire Clip
B
Screw
C
Screw
D
Stator
1. Remove screw securing stator wire clip; remove clip.
2. Remove screws securing stator to closure plate
bosses.
Remove Electric Starter
A
B
A
Nut
B
Starter
NOTE: Before removing, observe placement of starter
in closure plate for reassembly.
Remove nuts securing starter to closure plate. Remove
starter.
Remove Cylinder Head Baffl
e
A
B
A
A
A
Screw
B
Cylinder Head
Baffl e
Remove screws attaching cylinder head baffl e to cylinder
head and remove cylinder head baffl e.
Remove Valve Cover
A
B
A
Valve Cover
B
Screw
NOTE: Valve cover is sealed to cylinder head using
RTV silicone sealant. When removing valve
cover, use care not to damage sealing surfaces
of cover and cylinder head. To break RTV seal,
hold a block of wood against 1 fl at face of valve
cover. Strike wood fi rmly with a mallet. If seal
doesn't break loose after 1 or 2 attempts, repeat
procedure on other side.
1. Remove screws securing valve cover.
2. Remove valve cover from cylinder head.
3. Using a brass wire brush and gasket remover or
similar solvent, clean old RTV from surface of
cylinder head and valve cover.