Repair
Service and Repair Manual
Driving gear
u
Install a cap on the sample container.
u
Tighten the sample container cap by hand.
u
Install a new screw plug into the lower sample opening
2
.
Information
Always replace the screw plug.
u
Tighten the screw plug to torque.
(For more information see: Tightening specifications,
u
Fill in the sample form delivered with the sampling kit.
u
Place the sample container and form into the padded envelope and send them for analysis.
Specific values
Not applicable.
Tightening specifications
Fig. 118: Screw plugs for silicon oil collection
Reference
Key
Screw specifications
Lubricant *
Reuse**
Torque
Angle (°)
Step
± 5%
Step
± 5°
1
-
Screw plug
-
No
1 15 Nm
11 ft-lb
-
-
Tab. 27: Tightening specifications table
*Lubricants:
MG = Molykote G-n-plus
MW = Castrol Optimol paste white T
MH = Molykote HSC
108
© 2021 by Kohler Co. All rights reserved.
KD83V16 33525088901_2_1 EN_US
2021-07
