STARTING PROCEOURE
FUEL ON
CLOSE CHOKE
CRANK ENGINE (HAND)
CHECK POLARITY
TURN FUEL
VALVE TO
ON POS ITION
GRADUALLY RETURN
CHOKE TO OPEN
POSITION AFTER
ENGINE STARTS
PULL IN
DI RECTION
SHOWN - USE
STEADY MOTION
CRANK ENGINE (ELECTRIC START
NEGATIVE
(
-
)
GROUND
SYSTEM USED
1.
PULL IGNITION
KNOB OUT*
2.
DEPRESS AND HOLD
START BUTTON UNTIL
ENGINE STARTS
*OR MOVE TOGGLE
SWITCH TO "ON" POSITION
•
On engines with
10
AMP Magneto-Alternator, always dis connect leads hom Rectifier-Regulator
before doing any welding on equipment in common ground with engine .
•
To prevent overheating of starting motor, limit cranking time (continuous) to
60
seconds then allow
2
minute period before recranking (limit Motor-Generator to
30
seconds cranking).
STOPPING PROCEDURE
STOP BUTTON
DEPRESS AND
HOLD BUTTON
UNTI L ENG I NE
COMPLETELY STOPPED
SAFETY PRECAUTIONS
STOP
SWITCH
PUSH KNOB IN
OR MOVE SWITCH
TO "OFF" POSITION
•
Do nol add fuel while engine is running. Stop engine and, if possible, allow cooling period to
prevent spilled fuel from igniting on contact with hot engine parts.
•
Always disconnect spark plug cable to prevent unintentional starting
before
making any
adjustments on equipment powered by engine.
•
Make sure all safety guards on engine and driven equipment are in proper position and
secure.
•
Make sure hands, feet, and clothing are at a safe distance from any movable parts prior to
starting.
•
Do not tamper with governor settings.
The governor establishes safe operating limits.
These limits must not be exceeded.
2
