-5-
Check Connections for Leakage
6).
10-15
7).
C. Install and Remove the Apron
If the apron needs removing, please follow the steps
below:
1) Remove the screw cap and loosen the screw.
2) Push the upper part of the apron inwards, pull down
the apron and it can be removed easily.
3) When installing the apron, insert the top of the apron
into the enclosement, then fix and cap the screws.
IMPORTANT:
Your spa has been factory tested and
approved. It is the responsability of the installer to test
run the spa check all the fittings for leaks and test the
control functions.
NON OBSERVANCE WILL INVALIDATE FACTORY
WARRANTY.
C.
1).
2).
3).
D. Apply Sealant
1. After the bath is fixed, apply sealant around the bath.
D.
1.
Apply Silicone
Sealant
Apply Silicone Sealant
Apply Silicone Sealant
Apply Silicone Sealant
6).
Fill bathtub with water to the height of the
overflow and trial run the massage function for
10-15 minutes. Check all the fittings for leaks
and test the control functions. Check the pump
and pipes union connections for leaks. Hand
tighten union connections if required. Check
bath drains and overflow for leaks.
7). After installation, please trial run the massage bath
according to user's manual.
1206725-T01-A
