5
1216853-T01-B
INSTRUCTIONS FOR WHIRLPOOL WITH ELECTRONIC DRAIN (CONT)
!
!
Massage Strength Adjustment
When the pump is running, push the button "
" to
increase the
and push the button
"
" to decrease the
.
massage strength
massage strength
Pipe Cleaning
Start piping cleaning by pressing "
", and orange
light is on. Press again to stop pipe cleaning.
Meanwhile, electronic drain is open and green light is
on.
!
!
,
,
on/off
c
KOHLER
Pipe Cleaning
Electronic
Drain On/Off
/
Light
Pump On/Off
/
Water Temperature
Increase Flow
Decrease Flow
STARTING THE UNIT
If the unit does not function properly, please refer to the
"Troubleshooting" section.
Press the electronic drain on/off button "
" on the
user keypad to close the drain, and the red light
flashes.
Fill the bath to a level at least 2" (5 cm) above the
top of the nozzle.
Observe water temperature displayed on the keypad
for comfort and safety, run water to make sure of
water temperature.
Carefully enter the bath basin.
Press the pump on/off button "
" on the user
keypad.
Observe that the air system starts .
If desired, adjust the massage rate using the up
button"
"or the down button "
".
!
!
!
!
!
!
!
!
!
!
!
!
!
!
/
2"(5
)
/
on/off
on/off
OPERATING YOUR WHIRLPOOL BATH
